Need help?Do you have a question about the Carver A-500X and is the answer not in the manual?
Read all safety and operation instructions before operating the Carver Component.
Covers essential safety measures for operating the amplifier safely.
Advises against water, heat, and improper placement to ensure safe operation.
Outlines user servicing limitations and cleaning recommendations.
Lists key features like power output, THX certification, Magnified Current™ technology, and protection circuits.
Lists key technical specifications including Power Output, Frequency Response, Input Impedance, and Gain.
Details saving the sales receipt, noting the serial number, and filling out the customer registration card.
Provides guidelines for placing the amplifier, ensuring ventilation and avoiding hazards.
Explains removing handles and installing spacers for rack mounting.
Explains the function of the STEREO/MONO switch for stereo or bridged mono operation.
Describes the LEVEL controls for adjusting input sensitivity, especially for THX systems.
Details the function of the power switch, including LED indicator and output muting delay.
Explains the ballistically-weighted power meters, their calibration, and how to interpret readings.
Describes the button to turn the meter lights on and off for viewing adjustment.
Explains the function of the meter range switch to increase analog meter sensitivity.
Illustrates typical connections for normal stereo operation of the amplifier.
Provides specific notes for setting up two A-500x amplifiers in bridged mono configuration.
Shows a detailed connection diagram for a 5.1 surround sound setup using multiple amplifiers.
Illustrates how to connect speakers using bi-wiring, requiring separate cables for high and low frequencies.
Demonstrates bi-amplification, using separate amplifier channels for high and low frequency speaker inputs.
Explains Phono Level and Line Level audio signals and their typical uses.
Provides guidance on selecting appropriate speaker wire gauge based on length for optimal performance.
Details how to connect bare wire or banana plugs to the speaker terminals.
Explains how to attach banana plugs to speaker cables and insert them into the binding posts.
Details polarity requirements for stereo and mono modes to ensure correct phasing.
Describes internal fusing for amplifier protection and advises against user replacement.
Explains protection mechanisms against shorts, low impedance, and DC output.
Recommends in-line speaker fuses for speakers with insufficient power ratings.
Provides a formula and graph to determine the correct speaker fuse value based on power and impedance.
Lists common causes and troubleshooting steps for no sound or no power issues.
Provides troubleshooting steps for low or no output problems, focusing on sources, cables, and settings.
Addresses faint sound and sound cutting off issues with relevant troubleshooting steps.
Guides troubleshooting for single channel sound issues, checking balance, speaker connections, and cables.
Lists causes and solutions for hum and distortion, including cable routing and impedance.
Provides instructions on cleaning the amplifier's front panel and chassis using appropriate methods.
Advises on contacting the dealer or Carver Technical Service for product service and warranty.
To Next Page
General
