GLOBAL PARAMETERS
GLOBAL PARAMETERS
bO
- BYPASS OPERATION
(0 OR 1)
cont.
When set to 0, the bypass operation blocks all audio and leaves the direct signal as specified by the MIX (for more
on the MIX control see pg 7). When set to 1 (use the VALUE buttons), the bypass operation blocks all effect audio
and routes the uneffected signal straight through. Mode 0 is good for a console setup and mode 1 is good for a
guitar effect chain set up.
bF-
BYPASS FOOTSWITCH MODE
(0 OR 1)
Scroll again using the right EDIT button and you will come to the "bF" function.
When this particular function is set to 0, the footswitch tip bypasses EFF1 and the footswitch ring bypasses EFF2.
When set to 1, the tip and ring act as an EFF1 and EFF2 switching (such as on a 2 channel amp). When in stereo
mode the tip and ring act identically. It is not necessary to have a stereo plug. If a mono plug is inserted, the XP
processor will listen to the tip and ignore the ring.
Cx (C1 & C2)
-MIDI CHANNEL CONFIGURATION
Scroll to the right again to come to C1 & C2.
C1 and C2 allow you to set up what MIDI channel each engine is routed to (See MIDI section).
CE-
MIDI DATA ENABLE
(0 OR 1)
Scroll to the right to come to the "CE" function.
When set to 0, all MIDI data handling for this unit is disabled (both engines). The MIDI implementation includes
the ability to respond to effect program change commands and continuos controller events on controllers 96-104
(see MIDI section on pg 15).
To Next Page
Loading...
Need help?
General
