When the weight is not stable, the display will show average weight.
Used to increase the number to enter the limit value.
Used to save the limit value and select the mode.
Used to change the mode.
DESCRIPTIONSKEYS
How to Change Mode
If you want to use counting mode, press the MODE key until the display shows
“tyPE4” and then press the SET key.
Counting Mode
To count samples, you have to set the quantity.
Change the mode to counting mode and press the SET key.
Put 10 samples on the platter and press the SET key.
If the weight of sample is greater than the 0.5% of the full capacity, the counting
function will be performed. otherwise, the display will show “-----”.
The display will show “Put 20” or “Put 50” to request more samples if the loaded
weight is less than 0.5% of the full capacity.
Put 20 or 50 samples and press the SET key.
To perform counting function, the weight of 50 samples must be greater than 0.5%
of the full capacity.
To Next Page
Loading...
Need help?
General
