Need help?Do you have a question about the CAS NT-200A and is the answer not in the manual?
General| Capacity | 200 g |
|---|---|
| Calibration | External Calibration |
| Display | LCD |
| Measurement Range | 0 - 200 g |
| Weighing Units | g, ct, oz, ozt, dwt, gn, tl |
| Interface | RS232 |
| Storage Temperature | -10°C ~ 40°C |
Details the function and operation of the Zero key for input and control.
Describes the function and operation of the Tare key for weighing.
Explains the function of the Gross/Net key for switching display modes.
Describes the function of the Print key for printing current data.
Instructions for connecting the load cell to the indicator's port.
Explains the procedure to enter the test mode by pressing specific keys.
Details the steps to enter System Mode by pressing the ZERO key.
Instructions on accessing Calibration Mode using the Cal Switch Bolt.
Step-by-step guide for performing weight calibration, including unit selection.
Configures the number of points for multi-point calibration.
Sets the maximum weight the scale can measure.
Configures the minimum division or resolution of the scale.
Procedure for performing zero calibration to set the base point.
Sets the reference weight for calibration points.
Performs span calibration using a known weight.
Explains how to compensate for gravity differences during calibration.
Details a method for zero calibration using the Print Key.
Instructions on entering the Set Mode from normal operation.
Diagrams and pinouts for connecting the indicator to a PC using COM1.
Details the CAS protocol format using ASCII character codes.
To Next Page
