EasyManuals Logo

CAS SW-2 User Manual

CAS SW-2
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
5. How to Set Auto Power Off
Auto-Power off makes the battery's life longer.
When you don't operate the scale, this function makes the power OFF
automatically.
Before setting the Auto Power Off, make sure that the power is OFF.
While you press the ZERO
key, press the ON/OFF key,
then you will see the AP-10.
(If you have set this before,
display will show previous
value.)
Press the TARE key, until
the display shows the "AP-x0"
that you wish to take.
(Refer to TABLE 1.)
Press the ZERO key, then
the scale saves what you
programmed and shows all the
segments and count up "0" to "9".
DISPLAY FUNCTION
AP-00 This function does not make the power off automatically.
AP-10 If you don't operate the scale for 10 minutes, this function makes the power OFF.
AP-20 If you don't operate the scale for 20 minutes, this function makes the power OFF.
AP-30 If you don't operate the scale for 30 minutes, this function makes the power OFF.
TABLE 1.
BATTERY
LOW BATTERY
When the battery is low, display will show the "BAT".
Please, replace the battery by a new one. Battery is located on the bottom of the
scale.
If you use the scale without replacing the battery, display will show "LObAt" and
then scale makes the power OFF.
It means that you can't operate the scale any more. So you must replace the
battery by a new one.

Other manuals for CAS SW-2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CAS SW-2 and is the answer not in the manual?

CAS SW-2 Specifications

General IconGeneral
BrandCAS
ModelSW-2
CategoryScales
LanguageEnglish

Related product manuals