Casablanca ADVAN-TOUCH W-62 User Manual

1
ADVAN•TOUCH ♦ W-62 BRACKET/HOLSTER REMOVAL
Step 1. Remove the two
6-32 x 5/16” screws
holding the bracket to
the holster. Save screws
for later.
▲
▲
ADVAN•TOUCH ♦ CONTROL BRACKET INSTALLATION
Standard Light Switch
Step A. Remove the two screws holding the switch cover plate.
Do not remove the cover plate.
Step B. Orient the control bracket as shown and line up the
two inner mounting holes with those on the switch.
Step C. Install and tighten screws by hand only.
INNER
MOUNTING
HOLES
CONTROL
BRACKET
STANDARD
TOGGLE
SWITCH
SWITCH
COVER
PLATE
Rocker Light Switch
Step A. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch cover plate.
Do not remove the cover plate.
Step C. Orient the control bracket as shown and line up the
two inner mounting holes with those on the switch.
Step D. Install and tighten screws by hand only.
OUTER
MOUNTING
HOLES
CONTROL
BRACKET
ROCKER
TYPE
LIGHT
SWITCH
SWITCH
COVER
PLATE
Wall Installation
Step A. Locate a 2x4 wall
stud in a convenient
location.
Step B. Orient the control
bracket as shown over the
2x4 stud.
Step C. Use the 1” wood
screws in either the inner
or outer mounting holes.
Install and tighten screws
by hand only.
DECOR OVALHEAD SCREW
6-32 X 1”
ANCHOR
PANHEAD
SCREW
WOOD
SCREW 1”
DRYWALL ANCHOR
ADVAN•TOUCH ♦ ATTACH HOLSTER TO BRACKET
Note: The wall anchors and 6-32 x 1” screws may be
used in situations where mounting to a stud is not pos-
sible. Use the inner mounting holes. After securing the
anchor, discard the anchor’s pointed screws and use the
6-32 decor ovalhead screws supplied.
Step 2
After you have completed installing the bracket to the wall, using the 2 screws removed in Step 1, attach the W-62 holster to
the bracket.
CAUTION! Do not use with wall dimmer.
HOLSTER
BRACKET

Casablanca ADVAN-TOUCH W-62 Specifications

General

Device Type	Remote Control
Brand	Casablanca
Model	ADVAN-TOUCH W-62
Category	Remote Control
Compatibility	Casablanca ceiling fans
Control Type	Wireless
Power Source	Battery
Battery Type	AAA
Number of Batteries	2
Functions	Fan speed, Light control, Reverse function

Summary

Bracket and Holster Installation

Control Bracket Installation

Instructions for installing the control bracket on light switches.

Wall Mounting Bracket

Steps for securing the bracket to a wall stud or using drywall anchors.

Attach Holster to Bracket

Final step to connect the holster to the installed bracket.

Advan•Touch Remote Setup and Operation

Battery Installation and Operation Notes

Guide for inserting batteries and important notes on remote usage.

Fan and Light Operation

How to control fan speed, direction, and light dimming.

Special Operation Features

Details on Safe Exit and Bulb Saver features for lighting.

Advanced Features and Settings

Security Lighting Program

How to activate and use the random security lighting cycle.

Changing Frequency Settings

Instructions to set unique frequency codes for multiple fans.

Fan Troubleshooting Steps

Initial steps to resolve issues if the fan is not working.

Troubleshooting and Maintenance

Common Problem Resolution

Solutions for fan start issues, remote response, wobbling, and noise.

Fan Care and Safety

Guidance on cleaning, lubrication, and replacing light bulbs safely.