Cascade C Series - Page 2

Non-Sideshifting
A Mast Single Internal Reeving
OR
C LH THINLINEE 2-Port Hose Reel Group
Sideshifting
A Mast Double Internal Reeving
OR
A and C Mast Single Internal Reeving and
RH THINLINEE 2-Port Hose Reel
Group
OR
B and C RH and LH THINLINEE 2-Port Hose
Reel Groups
Solenoid Adaption
A and B Mast Single Internal Reeving and
RH Cable Reel Group
OR
B RH 6-N-1 Cable/Hose Reel Group
ONTENTS
C
ECOMMENDED HYDRAULIC SUPPLY OPTIONS
R
Recommended Hydraulic Supply i
Truck Requirements 1
Installation 2
Periodic Maintenance 7
i
C
B
C-Series Fork Positioners can be operated with any of the
hydraulic supply arrangements shown below. Refer to
Cascade
Hose & Cable Reel Selection Guide , Part No.
212199, to select the correct hose reel for the mast and
truck. Hose and fitting requirements are as follows:
• All hoses and fittings for the fork-positioning and
sideshifting (if equipped) functions should be at least
No. 6 with 9/32 in. (7 mm) minimum I.D.
This Manual provides instructions for installing Cascade
C-Series Fork Positioners.
Follow the suggested installation procedures for best
results. If you have any questions or need more informa-
tion, contact your nearest Cascade Service Department
(see back cover).
Read the WARNING Statements placed throughout this
Manual to emphasize safety during Fork Positioner installa-
tion.
IMPORTANT: Field alterations may impair performance or
capability and could result in loss of warranty. Consult
Cascade for any required modifications.
GA0033.ill
A