Case IH 3340 - Page 45

Index
P/N 016-0230-129 Rev. A 41
E
Electrical Safety 3
G
Gauge Wheel Installation 31
Gauge Wheel Mounting Locations 31
Mounting the Gauge Wheels 31
120’ Booms 32
90’-100’ Booms 31
H
Hydraulic Safety 2
Hydraulic System 17
Installing Fittings on the AutoBoom Valve 17
Installing the Left and Right Cylinder Hoses 20
Installing the Left and Right Down Hoses 21
Installing the Pressure and Tank Hoses 19
Mounting the AutoBoom Valve 18
UltraGlide Hydraulic Schematic 23
I
Important Safety Information
Electrical Safety
3
General 3
Instructions for Wire Routing 3
Hydraulic Safety 2
General 2
Instructions for Hose Routing 2
Introduction
Hydraulic
Fittings 6
Kit Contents 7
AutoBoom Installation Kit
120’ Booms 9
90’-100’ Booms 7
Hydraulic Kit 11
Optional Inner Ultrasonic Sensor Installation
Kit 12
Optional Wheel Kit
120’ Booms 14
90’-100’ Booms 13
Preparing or Installation 5
Point of Reference 6
Recommendations 6
Tools Needed 6
Updates 7
K
Kit Contents 7
P
Preparing for Installation 5
R
Replacement Parts 39
Sensors 40
Valve 39
S
Sensor Installation 25
Connecting the Sensor Cables 27
Mounting the Center Sensor 27
U
Ultrasonic Sensor Installation
Mounting the Boom Sensors 25
Boom Sensor Mounting Locations 25
Mount the Boom Sensors 26
W
Wiring
Connecting the Harness to the AutoBoom Valve
34
Connecting the Harness to the Power/CAN
Controls
35
120’ Booms 36
90’- 100’ Booms 35
Connecting the Harness to the Sensors 34
Installing the AutoBoom Node 33
Wiring Connections 33