2
TRIM THIS EDGE
TRIM THIS EDGE
LEFT PAGE
Template Name: OM_1_col
Template Date: 1994_04_29
Alt= to hide template information
Alt+ to display template information
TO THE USER
How to use this manual
Read this manual before operating your tractor. Call your retailer for further
information.
This manual contains important information concerning working, setting up
and maintaining your Case Steyr tractor safely. This manual is divided into
individual chapters corresponding to the contents so that you can easily find
information. Information concerning the tractor is divided into 4 chapters:
1. INSTRUMENTS AND CONTROLS – The layout of all controls is shown
here.
2. WORK NOTES – General notes on daily work with the tractor e.g.
starting up/turning off the tractor, operating the transmission etc.
3. OPERATIONAL USE – This chapter contains notes on various work
uses, specifically for use with implements, e.g. three-point linkage , rear
PTO etc.
4. TYRES/WHEELS/TRACK WIDTHS/BALLASTING – Settings for various
tractor working scenarios are described here, e.g. tyre pressures, track
widths etc.
Tractor maintenance is divided into two chapters:
1. LUBRICATION/MAINTENANCE – Regular maintenance intervals.
2. ELECTRICAL LAYOUT – General maintenance notes on electrics.
,03257$17See the alphabetical index at the end of the manual in order to
find a particular item in the manual concerning your machine.
Position descriptions such as in front, behind, right and left are understood to
be as seen from the tractor’s seat, facing in a forward direction.
Do NOT allow yourself or any other person to drive the machine or carry out
maintenance work without having first read the manual. Only employ trained
drivers who have shown their ability to correctly and safely work and maintain
the machine.
With its standard equipment and licensed fittings, this tractor is intended for
use in agriculture etc.
Do NOT use the machine for any other purpose other than those described in
the manual. Get in touch with an authorised retailer or the Case Steyr
Company concerning changes, additions or modifications which could be
necessary for your machine to fulfil the relevant national guidelines and safety
requirements. Release or approval from the manufacturer is required for
custom-built bodies. Unapproved changes render product liability void.
To Next Page
Loading...
Need help?
General