A WARNING
Study carefully this Manual before starting, operating, maintaining, fuelling or servicing the
machine.
Read and heed all safety rules before any intervention.
SAFETY RULES
Do
not allow unauthorised personnel to operate service
or maintain this machine.
-
Do
not wear rings, wrist watches, jewellery, loose or
hanging apparels, such as ties, torn clothing, scarves,
unbuttoned or unzipped jackets that can catch
on
mov-
ing parts. Wear proper safety equipment as recommend-
ed
for the job. Examples: hard hat, heavy gloves, ear
protection, safety glasses or goggles, reflector vests,
respirator. Consult your employer for specific safety
equipment requirements.
- Keep operator's compartment, stepping points, grab-
rails and handles clear of foreign objects, oil, grease,
mud or snow accumulation to minimise the danger of
slipping or stumbling. Clean mud or grease from shoes
before attempting to mount or operate the machine.
-
Do
not jump on or off the machine. Keep two hands and
one foot, or two feet and one hand
in
contact with step
grab rails and handles at all times.
-
Do
not use controls or hoses as hand holds when
climbing
on
or off machine. Hoses and controls are
movable and do not provide a solid support. Also,
controls may
be
inadvertently moved causing acciden-
tal machine or equipment movement.
- Never attempt to operate the machine or its tools from
any position other than seated
in
the operator's seat.
Keep head, body, limbs, hands and feet inside opera-
tor's compartment at all times, to reduce exposure to
hazards outside the operator's compartment.
Be careful of slippery conditions
on
stepping points,
hand rails, and on the ground. Wear safety boots or
shoes that have a high slip resistant sole material.
-
Do
not leave the machine until it
is
completely stopped.
- Check the seat safety belt at least twice a year.
If
there
are signs of wear or fraying or other signs of weakness
that could lead to failure, replace
it.
STARTING
- NEVER START NOR OPERATE
AN
UNSAFE MA-
CHINE. Before operating a machine, always ensure that
any unsafe condition has been satisfactorily remedied.
- Check brakes, steering and attachment controls before
moving. Advise the proper maintenance authority of any
malfunctioning part or system.
- Be sure all protective guards or panels are
in
place, and
all safety devices provided are
in
place and
in
good
operating conditions.
- Be sure exposed personnel
in
the area of operation are
clear of the machine before moving it or its attachments.
WALK COMPLETELY AROUND the machine before
mounting. Sound horn.
Before starting machine, check, adjust and lock the
operator's seat for maximum comfort and control of the
machine.
- Fasten your seat belt (when provided).
Obey all flag signals and signs.
- Due to the presence
on
the machine of flammable fluids,
never check or fill fuel reservoirs or batteries near open
flames, smoking materials or sparks.
- REMEMBER THAT STARTING FLUID
IS
FLAMMA-
BLE. Follow strictly the recommendations printed on
containers and
in
the Operation and Maintenance
Manual.
-
DO
NOT PUNCTURE OR BURN CONTAINERS.
- Containers must
be
stored
in
fresh, well ventilated plac-
es, out of reach of unauthorised persons. Follow strictly
the instructions provided by the Manufacturer.
- Never use these products near open flames, smoking
materials or sparks.
OPERATION
-
Do
not
run
the engine of this machine
in
closed areas
without proper ventilation to remove deadly exhaust
gases.
- Roll Over Protective Structures are required
on
loaders,
dozers, graders, excavators. NEVER OPERATE ma-
chines without ROPS.
- Make sure the Operator's compartment is free of foreign
objects, especially if not firmly secured. Never use the
machine to transport objects, unless proper securing
points are provided.
Find manuals at https://best-manuals.com
To Next Page
Loading...
