CHAPTER 6 – LUBRICATION / FILTERS / FLUIDS
6-10
Transmission Fluid Level
Check the transmission uid level while still warm. Put transmission in Neutral position, keep engine running at low
idle with parking brake applied. Turn rod of cover upper part clockwise to release it. Push out the cover and check the
dipstick. Add uid until the maximum mark of dipstick, as necessary. After the level has been checked, make sure that
the dipstick cover is properly tightened.
ZF TRANSMISSION FLUID DIPSTICK
Correct level with uid at operation temperature
Minimum with cold uid
ZF TRANSMISSION FLUID DIPSTICK
(845B / 865B / 885B MODELS)
FUNK TRANSMISSION FLUID DIPSTICK
FUNK TRANSMISSION FLUID DIPSTICK
(845B / 865B / 885B MODELS)
For additional information, refer to “Checking of Transmission Fluid Level” in the page 6-33 and 6-34.
To Next Page
Loading...
