Case 865B VHP - Engine Oil Change

CHAPTER 6 – LUBRICATION / FILTERS / FLUIDS
6-19
Engine Oil Change
Make sure engine is at operating temperature. Shut-off
the engine. Remove the drain plug (A) located on the lo-
wer right side of the engine crankcase and allow all the
oil to drain. Make sure the seal is in good condition and
install the drain plug.
Engine Drain Plug
Remove the oil lter. Carefully clean the gasket seat on
the lter.
NOTE: The seal ring usually sticks on the mating surface
of the lter head. Make sure to remove it .
IMPORTANT: Before installing, ll the oil lter with new
and clean oil. Before installing the lter, apply also a light
lm of oil in the area of the lter gasket seal.
IMPORTANT: Tightening the lter with a wrench can da-
mage it, therefore tighten it by hand. Then check if there
are leaks around the base when the engine is running.
Tighten it more if necessary. The proper torque is comple-
ted with 3/4” of a turn after contact by grasping the base
with both hands.
ENGINE OIL FILTER
Add specied oil, through the ller neck. Start the engine
and keep it running for 15 minutes to ll the lters and
lubricate the engine. Check the oil level and top off as
necessary. Check if there is any leakage from the lters.
LUBRICATION ANALYSIS
The normal engine oil change interval is every 500 hours
of operation or once a year whichever occurs rst. Ope-
rating conditions, quality of the engine oil and sulphur
content of the fuel can change this interval. It is recom-
mended to use the Systemgard. Lubrication Analysis Pro-
gram. See your dealer CASE.
IMPORTANT: Never drain oil or remove oil lter while en-
gine is running.
WARNING: Replace all covers or guards af-
ter servicing or cleaning the machine. NEVER
operate the machine with covers or guards
removed.