Case 865B VHP - Calibrating the Transmission (845 B; 865 B; 885 B Models with ZF Transmission)

CHAPTER 3 – INSTRUMENTS AND CONTROLS
3-22
Calibrating the transmission (845B / 865B / 885B models with ZF transmission)
Keep all unauthorized personnel clear of the area. 1.
Park the machine on a rm, level surface.
Run the machine to warm the transmission oil from 2.
160° to 175° F (70° to 80° C).
Place the transmission control lever in NEUTRAL.3.
Set the parking brake.4.
To exit the “Deseng.Park”, accelerate the engine abo-5.
ve 1500 rpm for a few seconds, and then return acce-
leration back to idle, the panel will be unlocked.
With the engine running, at idle, enter the service 6.
screen menu and scroll to “Cong” screen. Press the
conrm key.
Use down arrow button to scroll to “Clutch Calib.”. 7.
Highlight “Clutch Calib.”, and press the conrm key
“Conrm”. Always follow the prompts on the screen.
Should an error occur, use the escape key “Esc” to
start over again.
The screen will show a conrm prompt. If you doubt 8.
your ability to perform this operation, press the esca-
pe key and call your CASE dealer.
If machine conditions are incorrect, an error message 9.
will appear. The calibration procedure will not comple-
te. Follow the prompts to aid in correcting any machi-
ne conditions. The screen may display the following
prompts to guide the user to correct machine condi-
tions:
Not in neutral •
Park brake OFF •
Machine moving •
Oil temp too low •
Oil temp too high •
Engine RPM low •
Engine RPM high •
If conditions are correct the operator or technican will 10.
see six calibration screens pass. They will display in
this order:
Adjust K1 •
Adjust K2 •
Adjust K3 •
Adjust K4 •
Adjust KV •
Adjust KR •
Adjust WK (Lock-up) •
Once the process is completed this screen will direct 11.
the operator or technican to shut the engine OFF and
then re-start.
If the process is not completed the operator or techni-12.
can will be prompted to escape.