Case CX Series - RPM Control by Work Mode CX210;CX240

ELECTRICAL
4 - 14
CX EXCAVATORS
RPM CONTROL
Rpm Control for Each Mode (H, S and L), CX210/CX240
1) Maximum rpm is obtained by selecting H mode.
2) S mode speed is 200 rpm less than H mode.
3) L mode speed is 300 rpm less than H mode.
4) Auto mode speed varies, 150 rpm less than H mode to 250 rpm less than H mode.
5) Idle speeds are permanently stored in the controller memory.
The machine is in the Auto mode when the key switch is ON.
If the throttle knob is set at a lower rpm, speed changes will be different because of the
spring deflection of the throttle linkage.