Need help?Do you have a question about the Case CX160 and is the answer not in the manual?
General| Brand | Case |
|---|---|
| Model | CX160 |
| Category | Excavators |
| Language | English |
Identifies switches used for controller calibration and diagnostic system navigation.
Describes the procedure for controller reset and machine confirmation.
Procedure for calibrating the controller, including engine start and cushion switch use.
Procedure for inputting machine info and completing calibration for CX210/CX240.
Explains different diagnostic modes: Current Condition, Diagnostic System, Machine History, Resetting.
Displays past transistor output conditions if an over current was detected.
Lists current engine failure conditions and corresponding fault codes.
Displays hours for past engine failures and allows clearing data.
Lists current machine failure conditions and corresponding fault codes.
Displays hours for past machine failures and allows clearing data.
Displays resettable parameters like Hammer mode RPM, Altitude Compensation, Auto Power Boost.
Details setting engine speed for hammer mode on CX130/CX160 and CX210/CX240.
Details setting auto power boost for CX210/CX240.
Details how power boost increases main relief pressure for 8 seconds in H and S modes.
Covers Low Speed Travel, High Speed Travel, and Straight Travel operations.
Details Boom Raise, Boom Lower, Arm Open/Close, and Cushion operations.
Details energized travel speed solenoid, swash plate shift, and automatic switch to low speed.
Combined pump flows for boom raise, pilot pressure, and boom 2-speed.
Explains anti-drift valve, regeneration circuit for speed, and one pump flow for boom lower.
Combined pump flows for arm out, pilot pressure, and dual-pump operation.
Explains anti-drift valve, regeneration valve for speed, and dual-pump operation for arm close.
Power boost increases main relief pressure for 8 seconds in H and S modes.
Covers Low Speed Travel, High Speed Travel, and Straight Travel operations.
Details Boom Raise, Boom Lower, Arm Open/Close, and Cushion operations.
Details energized travel speed solenoid, swash plate shift, and automatic switch to low speed.
Combined pump flows for boom raise, pilot pressure, and boom 2-speed.
Explains anti-drift valve, regeneration circuit for speed, and one pump flow for boom lower.
Combined pump flows for arm out, pilot pressure, and dual-pump operation.
Explains anti-drift valve, regeneration valve for speed, and dual-pump operation for arm close.
Controller activates power boost solenoid to increase main relief pressure.
Provides set pressures, measuring methods, and readings for CX130.
Provides set pressures, measuring methods, and readings for CX160.
Provides set pressures, measuring methods, and readings for CX210.
Provides set pressures, measuring methods, and readings for CX240.
Explains the ECM, sensor inputs, system outputs, and data bus communication.
Describes fuel path: tank, lift pump, filter, VP44 pump, and injectors.
Steps for bleeding air, checking for air in fuel, and measuring pressures.
Explains engine control and protection fault codes, and fault code storage.
Lists fault codes, associated hardware, reasons, and their effects.
To Next Page
