CONTROLLER
3- 5
CX EXCAVATORS
CONTROLLER CALIBRATION PROCEDURE
1. Turn key switch “ON”
“?” is shown at MACHINE, TERRITORY and LANGUAGE areas.
“?” shown with dark background means that item is selected and ready
to select.
−
−−
−3 means CX series
2. The machine model code will change in the dark background area every
time the Travel mode switch is pressed.
Select the correct model code that corresponds with the machine.
MACHINE: SH ? –3
TERRITORY: ? LANGUAGE: ?
CONT. P/N KHR XXXX
MACHINE: SH0200 –3
TERRITORY: ? LANGUAGE: ?
CONT. P/N KHR XXXX
Machine Code Case NA
SH0120 CX130
SH0150 CX160
SH0200 CX210
SH0220 CX240
SH0250 Not Used
SH0300 CX330
SH0400 CX450
To Next Page
Loading...
