CONTROLLER
3 - 29
CX EXCAVATORS
SELF - CHECK CHK6
• R: Engine Load Ratio (CX210/CX240)
• FT: Fuel Temperature (CX210/CX240)
• TV: Throttle Volume
• TR1: Transistor output has detected an over current
• TR2: Transistor output has detected an over current
• TR3: Transistor output has detected an over current
• TR4: Not Used
NOTE: CHK6 does not appear on the screen. Transistor output can be
checked for over current (short to ground) automatically. To do this hold
down the one-touch idle switch while you turn on the key, then release the
one-touch switch. You will hear the system check itself. If there is no over
current is detected the travel alarm will sound.
CHK MODE 2 H
6 TR1 0 0 0 0
R 0 0 0 0 % TR2 0 0 0 0
FT 0 0 0 0 F TR3 0 0 0 0
TV 0 0 0 0 % TR4 0 0 0 0
To Next Page
Loading...
