CONTROLLER
3 - 51
CX EXCAVATORS
RESETTING
Auto Idle Time Set
Push the Buzzer stop switch to select AI (item selected will have a light
background).
To set the Auto-Idle time from 0 through 30 seconds, press the Travel
mode switch until the number changes to your selection. The number
increases by 1 every time the switch is pushed.
To save this data press and hold the Work mode switch for 10 seconds.
The buzzer will sound to notify when 10 seconds have elapsed.
Turn the key switch off to complete the procedure.
RST MODE Hi, H
1 PA 0 0 0 0
BRK 0 0 0 0 RPM AU 0 0 0 0
L/M Not Used RPM HLD 0 0 0 0
AI 0 0 0 0 SEC OUT Not Used
To Next Page
Loading...
