SECTION 2 - OPERATION
2-14
Back away from stock pile, lowering loader slowly.
Sudden stops when lowering bucket quickly can
result in damage to loader and/or tractor’s hydraulic
system.
0150
28
Raise loader while approaching vehicle so bucket
does not strike vehicle when bucket is dumped.
Release load from a low position for better loading
and less spillage.
IMPORTANT: Do not use loader as a battering ram.
29
When back--grading, angle the bucket downward to
allow cutting edge to contact ground and prevent
wear on bucket rear face.
IMPORTANT: To prevent damage to loader, do not
back grade material with bucket in the full dumped
position. Bottom of bucket should be no more than
45
°
from the ground during back grading.
0165
30
To Next Page
Loading...
