Case L780 - Operation with Bale Spike Attachment

SECTION 2 - OPERATION
2-19
OPERATION WITH BALE SPIKE
ATTACHMENT
WARNING
DO NOT move large round bales using loader
unless equipped with an approved round bale
attachment. Without these, the bale can fall on
the operator when the loader is raised causing
severe injury or death.
WARNING
Prevent personal injury due to machine tipping.
Use extreme caution when turning, loading, and
moving bale. Use adequate rear ballast.
CAUTION
Forward visibility is reduced when moving large
round bales.
CAUTION
Prevent personal injury due to being struck by a
“run--away” bale. Use proper bale handling
equipment when stacking round bales. Set bales
down on level ground. “Run--away” bales can
cause personal injury and/or property damag e.
Move the bale spike into position at the end of the
bale.
Make sure the bale spike is centered left to right and
top to bottom with relation to the bale.
Drive forward slowly into the bale until spike fully
penetrates the bale.
40