page 1-28 Part 1. Operation Manual Rev. 03-2004
Bill Acceptor FL Series Service Manual
MODULAR
SYSTEM
.oNniprotcennoC eriwforoloC
1 deR
2 nworB
3 wolleY
4 kcalB
5 eulB
6 yarG
7 kniP
8 egnarO
9 neerG
detcennoctoN naT
11 teloiV
21 etihW
Accessories, typically supplied with the Bill Validator, include an extractor (a special tool for replacing
the Sense-a-Click
®
sensor pak Lower module, part number OPT-HW-FT01) and a harness (cable)
for external connections.
ACCESSORIES
For a download via the interface connector, the following accessories must be used:
If no special requirements have been indicated, then the cable will automatically come with 12 “loose”
wires at one side and a 12-pin JAE connector attached to the other side. The total length of cable is 1
meter. The chart below gives information about wire color and connection to the connector pin.
The harness part number is FL-HS-JAE-05.
A customized harness is also available, to suit your special needs.
OPT-HW-FT01
eludoMecafretnIrewoP
lliBdaoLtnorFnidesu
rotadilaV
trapretpadA
rebmun
ecafretnI
0171-PLF
CP-LF-2SP-TPO
PDBLF-CC
0172-PLF
9BD-EAJ-2SP-TPO
)V21(TENCC,SPDB-LF
0182-PLF LPI-CC
0175-PLF noosgnimoc )V42(TENCC,22CPG-CC
To Next Page
Loading...
