4. Configure the date and time settings.
●
While the seconds are flashing,
pressing (E) will reset them to 00. 1 is
added to the minutes when the current
seconds count is between 30 and 59
seconds.
●
For all the other settings, use (B) and (E)
to change the flashing setting.
Holding down (B) or (E) scrolls through
settings at high speed.
5. Repeat steps 3 and 4 to select time and
date settings.
6. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
●
Switching between 12-hour and 24-
hour Timekeeping
You can specify either 12-hour format or 24-
hour format for the time display.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
●
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
3. Press (D) eight times.
This causes [12H] or [24H] to flash on the
display.
4. Press (E) to select [12H] (12-hour
timekeeping) or [24H] (24-hour
timekeeping).
24-hour
timekeeping
12-hour
timekeeping
5. Press (A) to complete the setting
operation.
Note
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Using the Watch in a Medical
Facility or Aircraft
Whenever you are in a hospital, on an aircraft,
or in any other location where connection with
a phone may cause problems, you can
perform the procedure below to disable auto
time adjustment. To re-enable auto time
adjustment, perform the same operation
again.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
●
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
3. Press (D) 14 times.
This displays [RCV].
4. Press (E) to toggle between the auto time
adjustment settings.
[OFF]: Auto time adjustment disabled.
[ON]: Auto time adjustment enabled.
5. Press (A) to complete the setting
operation.
Note
●
The auto time adjustment setting can
be changed only while the watch is
paired with a phone.
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Watch Operation Guide 5707
17
To Next Page
Loading...
Need help?
General
