Casio 5724 - Checking the Watch Charge Level; Recording Your Current Location (TIME & PLACE); Connection; Connecting with a Phone

Checking the Watch Charge
Level
Use the procedure below to check the current
charge level with CASIO WATCHES.
1.
Y
Tap the “CASIO WATCHES” icon.
2.
X
Hold down (C) for at least three
seconds. Release the button when
[CNCT] and
e
start to flash.
When a connection is established
between the watch and phone, [CNCT]
and
e
will stop flashing and remain on the
display.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the Timekeeping Mode.
ConnectedTrying to connect
3.
Y
Use CASIO WATCHES to check the
charge level.
Recording Your Current
Location (TIME & PLACE)
While traveling or otherwise on the go, you can
use the procedure below to record your
current location, along with the time and date,
on your phone. Recorded location information
can be viewed on a CASIO WATCHES map
while the watch is connected with your phone.
●
Recording Your Current Location
1.
X
Enter the Timekeeping Mode.
l
Navigating Between Modes
2.
X
When you are in the location you want
to record, press (D).
This records, in phone memory, the
latitude and longitude of the location you
are in when you press the button, along
with the date and time.
●
[OK] appears when registration is
complete. [ERR] appears when
registration fails.
●
At this time the time settings of your
phone and watch will be synced with
each other.
●
Viewing a Recorded Location on a Map
1.
Y
Tap the “CASIO WATCHES” icon.
2.
Y
Perform the operation shown on the
phone screen to view recorded location
information.
Note
●
You can use CASIO WATCHES to
delete recorded location information.
Connection
Connecting with a Phone
Your watch can connect with a phone that is
paired with it.
●
If the watch is not paired with the phone you
want to connect with, refer to the information
below and pair them.
l
C
Pair the watch with a phone.
●
Connecting with a Phone
1. Move the phone close to (within one meter
of) the watch.
2.
X
Hold down (C) for at least three
seconds. Release the button when
[CNCT] and
e
start to flash.
When a connection is established
between the watch and phone, [CNCT]
and
e
will stop flashing and remain on the
display.
●
If connection fails for some reason,
[ERR] will appear on the display
momentarily and then the watch will
return to the Timekeeping Mode.
ConnectedTrying to connect
Watch Operation Guide 5724
14