Recording and Playing the Sounds You Want (Sampling)
EN-221
6.
Press TYPE.
This displays “LOOP”, which means that the sound will loop.
• In the case of a looped sound, the loop time is determined according to the note value used as
the unit and the number of loops.
7.
Rotate the dial to select the note value.
This displays the –/+ screen.
• After you rotate the dial once to select a note value, you can change the selection further using
– and +.
• To go back to the previous screen, press BACK.
8.
Press TIMES.
To Next Page
Loading...
