Controlling the Sound of a Performance
EN-12
You can use the pitch bend wheel to smoothly slide the pitch
of notes you are playing upwards and downwards. This
capability makes it possible to reproduce electric guitar
choking and saxophone note bending effects.
1.
While playing a note on the
keyboard with your right hand,
rotate the pitch bend wheel
upwards or downwards with your
left hand.
The amount the note bends depends on
how much you rotate the pitch bend
wheel.
You can specify, in semitone units, how much the pitch
changes when the pitch bend wheel is at maximum rotation in
either direction.
1.
Press FUNCTION.
This displays the [FUNCTION] screen.
2.
Use the U and I buttons to select
“PitchBendRange”.
• To go back to the previous screen, press the EXIT
button.
3.
Rotate the dial to set the pitch bend range.
• You can specify a pitch bend range of 0 to 12.
• After you rotate the dial once to select an option, you
also will be able to change the selection using the –
and + buttons.
• To return the setting to its initial default, press the –
and + buttons at the same time.
• To go back to the previous screen, press the BACK
button.
4.
Press FUNCTION to exit the setting screen.
While sustain is enabled, notes are sustained longer when
keyboard keys are released.
1.
Press SUSTAIN.
This momentarily displays “SUSTAIN ON”.
• “SUS” at the top of the display indicates that sustain is
enabled.
2.
To disable sustain, press SUSTAIN again.
You can use the procedure below to add reverb to the notes
you play.
1.
Press FUNCTION.
This displays the [FUNCTION] screen.
2.
Use the U and I buttons to select “Reverb”.
• To go back to the previous screen, press the EXIT
button.
3.
Rotate the dial to select the reverb type.
Available reverb type settings are: Off, Room 1 to 4, Hall
1 to 4, and Stadium 1 and 2.
• After you rotate the dial once to select an option, you
also will be able to change the selection using the –
and + buttons.
• To return the setting to its initial default, press the –
and + buttons at the same time.
• To go back to the previous screen, press the BACK
button.
Using the Pitch Bend Wheel
Specifying the Pitch Bend Range
Using the SUSTAIN Button
Adding Reverb to Notes
To Next Page
Loading...
