Casio Cassiopeia EM-500 Getting Started Guide

21
• Do not have the serial cable and USB cable connected to the cradle at the same time.
When using one, be sure to unplug the other.
• Note that after connecting the cradle to your computer, you also need to make certain
ActiveSync settings on your computer to enable data transfers. See the ActiveSync
Help for details about setting up and using ActiveSync.
Using the CASSIOPEIA USB Cable
You can use the CASSIOPEIA USB cable to connect the CASSIOPEIA directly to a
computer.
Important
• See “Required System Configuration” on page 22 for the computer system that is
required for direct USB connection.
• The illustration below is just one possible connection configuration. The location and
layout of USB ports vary from computer to computer. See the documentation that
comes with your computer for full details on connecting cables to it.
• You must have ActiveSync installed on your computer in order to exchange data with
the CASSIOPEIA over a USB connection. See the Pocket PC User’s Guide for
information on installing and using ActiveSync.
To connect to a computer using the CASSIOPEIA USB cable
1. Plug the USB cable into the USB port of your computer.
2. Turn off your CASSIOPEIA.
3. Connect the other end of the USB cable to your CASSIOPEIA.
USB port
CASSIOPIEA USB cable

Casio Cassiopeia EM-500 Specifications

General

Brand	Casio
Model	Cassiopeia EM-500
Category	Software
Language	English