Casio CELVIANO AP-270 User Manual

EN-10
Playing with Different Tones
1. Press the METRONOME button.
• This starts the metronome.
• The lamp flashes with each beat.
2. While holding down the FUNCTION button,
press the METRONOME BEAT keyboard
key.
• Keep the FUNCTION button depressed as you
advance to step 3.
3. Hold down the FUNCTION button and press
the BEAT keyboard key (0 to 9) that
corresponds to the beat you want to specify.
• You can specify a beat value in the range of 0 to 9
(beats per measure). A chime will sound on the first
beat of each measure, and clicks will sound for the
remaining beats. Specifying 0 plays a straight click,
without any chime. This setting lets you practice with
a steady beat.
4. Release the FUNCTION button and then hold
it down again as you press the
METRONOME TEMPO keyboard key.
• Keep the FUNCTION button depressed as you
advance to step 5.
5. While holding down the FUNCTION button,
use the TEMPO keys to specify a tempo
value in the range of 20 to 255 beats per
minute.
• Each press of the + or – key raises or lowers the
tempo value by 1.
• You can also use the tempo value input keys (0 to 9)
to enter a specific tempo value.
• Input three digits as the tempo value.
Example: To set a tempo of 20, press keys 0, 2, and
then 0.
6. Press the METRONOME button to turn off
the metronome.
NOTE
• If you used the numeric input (0 to 9) keyboard keys
to input beat and/or tempo values and the values
are within the allowable setting ranges, the Digital
Piano will emit a high pitch beep when you release
the FUNCTION button. If a value is outside the
allowable range, a low-pitch sound will be emitted.
• You could also use the procedure below in place of
steps 4 and 5 of the above procedure to specify a
tempo value.
– While holding down the FUNCTION button, use
the TEMPO keyboard keys to specify a tempo
value in the range of 20 to 255 (beats per minute).
• In step 5 of the above procedure, pressing the + and
– keys at the same time will set the tempo of the
Concert Play lesson song or Music Library song (in
the case of a recorded song, the tempo when the
song was recorded) that was last selected on the
Digital Piano.
Using the Metronome

Casio CELVIANO AP-270 Specifications

General

Touch Response	3 sensitivity levels, Off
Tones	22 built-in tones
Pedals	3 pedals (damper, soft, sostenuto)
Speakers	12cm x 2
Amplifiers	8W + 8W
USB Port	Type B
Power Consumption	18W
Keyboard	88 keys, Tri-sensor Scaled Hammer Action Keyboard II
Sound Source	AiR Sound Source
Digital Effects	Reverb (4 types), Chorus (4 types), Brilliance, DSP
Songs	60 Music Library tunes, 10 User Songs
Recording	2 tracks, 1 song
Lesson Function	Part ON/OFF
Metronome	0 to 9 beats, tempo range: 20 to 255
Key Transpose	-12 to 0 to +12 semitones
Tuning Control	A4 = 415.5 to 440.0 to 465.9 Hz
Headphones	2
MIDI	Yes
Power Supply	AC adaptor: AD-A12150LW
Included Accessories	AC Adaptor, Music Stand
Polyphony	192 notes