Recording Your Keyboard Play
EN-51
8.
Press
cs
twice to exit the recorder mode.
• The flashing on the screen shown in step 3 becomes
faster when remaining recorder memory capacity
becomes less than 100 notes.
• Total recorder memory capacity is approximately
12,000 notes. Recording will stop automatically when
there is no more unused recorder memory remaining.
• Each press of
cs
cycles through the settings shown
below. You can listen to the recorded data as many
times as you like by pressing
bk
while in playback
standby.
■ To delete recorded data
After step 3 of the above procedure, do hold down
cs
(without pressing any keyboard key) until the message
“Tr.Del?” appears on the display. Press [+] (YES) to delete the
data, or [–] (NO) to cancel the delete operation.
• Turning off the Digital Keyboard while recording is in
progress will cause any data in recorder memory to be
deleted.
• A new recording replaces (deletes) previously recorded
contents.
You can divide a song according to various types of parts
(instrument, left and right hand, etc.), and record each part to
a specific track. You can mix up to six tracks (the original track
plus five additional tracks) into a final song.
■ About tracks
Tracks are numbered from 1 to 6.
• If you do not specify a track number when recording,
recording is performed to Track 1 automatically.
In addition to what you play on the keyboard, the following
information also is recorded.
• Track 1
Settings:
Tone number, rhythm number, tempo, VIRTUAL HALL,
reverb, chorus, chords, layer/split settings, Auto
Harmonize/Arpeggiator setting
Operations:
Pedal, pitch bend wheel, INTRO button, SYNCHRO/
ENDING button, NORMAL/FILL-IN button, VARIATION/
FILL-IN button
• Tracks 2 through 6
Tone number, pedal operation, pitch bend wheel operation
Disappears
Recorder Off
Playback
Standby
Record Standby
Using Tracks to Record and Mix
Parts
CTK860IN_A5_x1a_EN.indd 53 2014/07/10 18:06:46
To Next Page
Loading...
Need help?
General
