E-22
Playing a Built-in Tune
Looping a Musical Phrase
You can select one or more measures and “loop” them, which
means that they play again and again until you stop playback.
1
While the tune is playing, press the REPEAT button
while the measure you want to start from is playing.
• This causes the repeat indicator to flash on the display.
2
When playback is within the measure you want to
specify as the end of the loop, press the REPEAT
button again.
• This causes the repeat indicator to light on the display.
• To cancel repeat play of a loop, press the REPEAT
button again so the repeat indicator is not displayed.
To change the melody tone
1
Press the TONE button.
2
Find the tone you want in the TONE List, and then
use the number buttons to input its three-digit
number.
Example: To select “131 VIOLIN”, input 1, then 3, then
1.
• You can select any one of the keyboard’s built-in tones.
NOTE
• You can also use the [+] and [–] buttons to change the
melody tones.
• Specifying the tune number for the same tune that is
currently selected returns the melody tone to the default
setting for that tune.
Viol in
Indicator
appears
To play all tunes in succession
1
Press the RHYTHM button and TONE button at the
same time.
• Playback starts from Song Bank tune number 001.
2
To stop tune play, press the PLAY/STOP button.
NOTE
• While a tune is playing, you can use the number buttons
or [+] and [–] to change to another tune.
• You can play along with the tunes on the keyboard.
CTK810IN_e_20-27.p65 07.4.10, 3:47 PM22
To Next Page
Loading...
Need help?
General
