52
Basic Parameter List
Note 1:
Number of the tone allocated to this part.
Note 2:
Sets the Normal, Drum and Drawbar Organ modes of the part play operation. For detailed operations, see "12.1 About the
Part Mode".
Tune / Mix parameter
Tone parameter
Note 1:
Change the tone name. One character is indicated by each byte.
ParamID Parameter bit Value Default Setting Value (Decimal)
50 Tone Number (Note 1) 0E 000 000-FFF
51 Part Octave Shift 03 2-6 4 -2 to 0 to +2 Oct
52 Part Enable 01 0-1 1 0...Disable (Off)
1...Enable (On)
53 Part Mode (Note 2) 04 0-4 0 0...Normal
1...Rhythm
2...Drawbar
ParamID Parameter bit Value Default Setting Value (Decimal)
54 Pitch Fine Tune 08 00-FF 80 -99 to 0 to +99cent
55 Pitch Coarse Tune 07 28-58 40 -24 to 0 to +24 semi
56 Volume 07 00-7F 7F 0-127
57 Accomp Volume 07 00-FF 7F 0-127
58 Bend Range 07 00-18 02 0-+24
59 Pan 07 00-7F 40 -64 to 0 to +63
ParamID Parameter bit Value Default Setting Value (Decimal)
60 Tone Name A (Note 1) 20 0-FFFFFFFF 556e7469
MSB is leading character.
61 Tone Name B (Note 1) 20 0-FFFFFFFF 746c6564
MSB is leading character.
64 Line Select 01 0-1 0 0...Thru
1...DSP
65 Tone Octave Shit 03 2-6 4 -2 to 0 to +2 Oct
66 Tone Attack Time 07 00-7F 40 -64 to 0 to +63
67 Tone Release Time 07 00-7F 40 -64 to 0 to +63
68 Tone DCF Cutoff 07 00-7F 40 -64 to 0 to +63
69 Tone DCF Resonance 07 00-7F 40 -64 to 0 to +63
6A Chorus Send 07 00-7F 00 0-127
6B Reverb Send 07 00-7F 32 0-127
6C Tone Level 07 00-7F 7F 0-127
6D Tone Touch Sens 07 00-7F 7F -64 to 0 to +63
To Next Page
Loading...
