E-52
706A-E-054A
Troubleshooting
Cannot record chord
accompaniment data on a
computer.
Static noise when a microphone is
connected.
No microphone sound
ACCOMP OUT is turned off.
1. Use of a microphone that is a
different from the type that is
recommended.
2. Use of the microphone in the
vicinity of fluorescent lighting.
1. Microphone volume setting is
too low.
2. Microphone on/off switch is set
to OFF.
Page E-50
Page E-29
Page E-29
Page E-29
Page E-29
Turn on ACCOMP OUT.
1.Use a recommended type
microphone.
2. Move the microphone away from
source of the static.
1. Increase the microphone volume
setting.
2. Change the microphone on/off
switch setting to ON.
Problem Possible Cause See pageAction
This is an unavoidable result of the digital sampling process,* and does not indicate
malfunction.
* Multiple digital samples are taken for the low range, middle range, and high range of
the original musical instrument. Because of this, there may be a very slight difference
in tonal quality and volume between sample ranges.
A tone’s quality and volume
sounds slightly different
depending where it is played on
the keyboard.
To Next Page
Loading...
