Casio CZ-3000 User Manual

* PART 2
*
TONE
MIX MODE
wmmi^^m
TONE
M
With
the CZ-3000, two different
timbres can be mixed for
output, The volumes of
the
individual timbres that make
up a tone mix
can be independently controlled. At this time,
the keyboard becomes 4-note polyphonic.
,
Oj Press the
TOME
MIX key.
TONE
MIX
L_L_t
v
J.
*"""
X w
LL
v
iu"™
1
,1,
*m
Volume level of
TONE 1 Volume level
of TOME 2
(2)Tones can be selected and the volume can be
set for
the position (LEV 1/LEV
2)
at which
the cursor is located. In
the
situation
shown above, the cursor is below the level for TOME
1,
and so the timbre and volume level
can be changed.
•Select
1 timbre using the PRESET
and MEMORY BANK keys
in the Programmer
Section.
*Cse the VALUE keys
to set the volume level within
a range of 1 through
15. A
setting
of
15 represents maximum volume.
fB\
3) Use the
(V]
CURSOR
key in
the Data Entry Section
to move the cursor under the LEV
2
value.
Set
the timbre and volume
level in the same
manner as that outlined for LEV
L
EFFECT/OVERALL
CONTROL
The Effect
and Overall Control Sections
operate just
as in the NORMAL MODE
for tone
mixed
timbres, Setting
procedures are identical, and each function is
commonly applied
to both of the mixed
timbres,
•PORTAMENTO
TIME and ON/OFF
•GLIDE/NOTE
and ON/OFF
•PITCH
BEND and MODULATION
DEPTH
•MASTER
TUNE
and KEY TRANSPOSE
*
With the exception of
MODULATION,
effect ON/OFF
can be independently
set in 3 modes:
NORMAL, TONE
MIX and KEY
SPLIT Each
effect data (numeric)
and modulation
ON/OFF
are common for
3 modes.
*Monophonic play of
the tone mixed
data is possible when
the SOLO key
is ON.
red in i
Tone
mix settings
are stored in
memory, so
they are not cancelled
by changing
to
another mode
and then
back to the TONE
MIX
mode.
*
However,
though TONE
1
and TONE
2 and the volume
level
are retained, all effects
are
turned OFF
when the
power of the
unit is switched OFF
PART 2 TONE
MIX MODE
Zfl

Casio CZ-3000 Specifications

General

Brand	Casio
Model	CZ-3000
Category	Synthesizer
Language	English