Casio DT-970 Series - Applicable Standards; DT-970 Compliance

26
3.3. Mechanical Specification
3.3.1. DT-970
The mechanical specification (dropping impact, vibration resistance) of the DT-970 Series (all models) is
as follows:
Table 3-7 Mechanical Specification
Item Specification Conditions
Dropping impact 2.0m 6 sides and 4 corners, one time each, onto concrete
Fit the packaged batteries (LR6) and eneloop batteries in
place
Vibration resistance 1.5G or less 10 to 55Hz, XYZ directions, 30 minutes round trip
Power On (display light only)
3.3.2. USB cradle HA-N60IO
The mechanical specification (dropping impact, vibration resistance) of the USB cradle (HA-N60IO) is as
stated in the table below.
Table 3-8 Mechanical Specification
Item Specification Conditions
Dropping impact 75cm 6 sides, one time each, onto concrete
Vibration resistance 1.5G or less 10 to 55Hz, XYZ directions, 30 minutes round trip
With power on but not communicating
3.3.3. LAN cradle HA-N62IO
The mechanical specification (dropping impact, vibration resistance) of the LAN cradle (HA-N62IO) is as
stated in the table below.
Table 3-9 Mechanical Specification
Item Specification Conditions
Dropping impact 75cm 6 sides, one time each, onto concrete
Vibration resistance 1.5G or less 10 to 55Hz, XYZ directions, 30 minutes round trip
With power on but not communicating