– 26 –
DT-X200/DT-X8
5-4-4. Initial Settings
1. Registration and confi rmation of Product ID
No. Operation Display Test Details
1
Start up
“
IDSET_PY-052
”
under
\\My Device\FlashDisk\DIAG.
Check that an individual ID write
tool has been started up.
2
Enter the barcode serial number
(individual ID) written on the
back side of DT-X200/DT-X8.
Note:
Enter only the rightmost 14
digits of the written number.
14 digits
(to be continued)
3
Press the
“Enter”
key or tap
“
[ENT] OK
”
.
Tap
“
OK
”
.
Check that the message
“
Model/ID
Setting Successed
”
is shown.
DT-X200/DT-X8 restarts
automatically.
4
Start up
“
IDCHK_PY-052
”
under \\My Device\FlashDisk\
DIAG to see that the product ID
is correctly registered.
To Next Page
Loading...
Need help?
General