– 19 –
DT-X200/DT-X8
5. HARDWARE TEST/SETTING
5-1. General
In this chapter, how to check the hardware of DT-X200/DT-X8 is explained.
The general fl ow to start up the test program is as follows:
Prepare equipment required.
PC
Obtain the test program Diag_dtx200-x8.zip
(Download from website.)
Unzip Diag_dtx200-x8.zip and copy it to a MicroSD card.
(For both test object DT-X200/DT-X8 and opponent DT-X200/DT-X8)
DT-X200/DT-X8
Install the MicroSD card.
Copy the test program from the MicroSD card to the FlashDisk.
Prepare equipment required.
Remove the MicroSD card.
Start the test program.
Perform Initial Settings
Perform function tests.
Delete the test program from the FlashDisk.
To Next Page
Loading...
Need help?
General