Disabling the Countdown
Start Tone
You can use the procedure below to enable or
disable the countdown start tone that sounds
when the function hand starts a countdown
operation 30 minutes before an alarm time or
before the end of a timer operation.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
●
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
3. Press (C) 10 times (or 11 times).
This causes [PROGRESS♪] to appear.
Next, [♪ON] or [♪OFF] will flash on the
display.
4. Press (D) to select [♪ON] or [♪OFF].
[♪ON]: Tone enabled.
[♪OFF]: Tone disabled.
5. Press (A) to exit the setting screen.
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds
until the name of the currently selected
Home City is displayed.
●
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
3. Press (C) 11 times (or 12 times).
This causes [KEY♪] or [MUTE] to flash on
the display.
4. Press (D) to select [KEY♪] or [MUTE].
[KEY♪]: Operation tone enabled.
[MUTE]: Operation tone muted.
5. Press (A) to exit the setting screen.
Note
●
Note that alarm and timer tones will still
sound even while the operation tone is
muted.
Configuring Power Saving
Function Settings
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds
until the name of the currently selected
Home City is displayed.
●
This is the setting mode. The hands
automatically shift out of the way for
easy viewing of the display and other
indicators.
3. Press (C) 14 times (or 15 times).
This displays [PSON] or [PSOF].
4. Press (D) to toggle between ON and OFF.
[PSON]: Power Saving enabled.
[PSOF]: Power Saving disabled.
5. Press (A) to exit the setting screen.
Note
●
For details about Power Saving, refer
to the information below.
l
Power Saving Function
Watch Operation Guide 5658
24
To Next Page
Loading...
