98
Other Settings (Set Up)
Procedure
MENU * Setup * HDMI
Use this setting to select the digital signal format when connecting to a TV with an
HDMI cable.
* 1080i corresponds to 1080 60i, but not 1080 50i. Because of this, the required
output method may be 576p when outputting to a digital TV in a PAL reception area
that does not support 1080i 60i. If you are in a PAL reception area and nothing is
displayed automatically, change the setting to 576p.
• If an image does not appear when “Auto” is selected as the output method, try
changing this setting to something else.
Procedure
MENU * Setup * Startup
Selecting “On” for Startup causes a built-in startup screen to appear on the monitor
screen whenever the camera is turned on.
Selecting the HDMI Terminal Output Method (HDMI)
Auto
This setting will cause the format to change automatically in accordance
with the connected TV. Normally, you should use this mode.
1080i 1080i format output*
480p 480p format output
576p 576p format output
Displaying a Startup Screen at Power On (Startup)
To Next Page
Loading...
Need help?
General
