13-8
- Clipboard and history data (Including the “SYSTEM” data item.)
- e • ACT mode data*
1
- S • SHT mode data*
1
*
1
Can be transferred from an fx-9860GII SD, fx-9860GII, fx-9860G AU PLUS, fx-9860G
Slim (OS 2.00), fx-9860G SD (OS 2.00), fx-9860G (OS 2.00) or fx-9860G AU (OS 2.00)
calculator.
• Program data is transferred as-is.
However, any command in a transferred program that is not supported by the fx-7400G
II
will be replaced by the at sign (@). Running such a program on the fx-7400GII will cause an
error.
S Sending Data from an OS 2.00 Calculator to any Older Model Calculator
The following are general rules that apply when transferring data from an OS 2.00 calculator to
an fx-9860G series or CFX-9850G series calculator.
• The following data is not transferred.
- String memory data
- TVM mode bond calculation and depreciation calculation data
- STAT mode function and variable data for which there is no corresponding function for
variable on the receiving calculator model (Example:
Ƶ
2
GOF Test calculation result data,
etc.)
• The following data is converted by the OS 2.00 calculator to a format that is supported by the
receiving calculator model before it is sent.
- GRAPH mode, DYNA mode Graph Type setting data
When transferring to an fx-9860G series or CFX-9850G series calculator, X=, X>, X<, XP,
and XO type expressions are converted to an X=c type expression
- Graph line type setting data
When sending to a CFX-9850G series calculator, line settings are converted as follows
before being sent: Normal: Blue; Thick: Orange; Broken, Dotted: Green.
- STAT mode Graph1, Graph2, and Graph3 setting data
When sending to an fx-9860G series calculator, pie and bar type graphs are converted to
ScatterPlot before being sent. Other settings are not sent.
• Program data is transferred as-is.
However, any command in a transferred program that is not supported by the other model
calculator will be replaced by the at sign (@). Running such a program on the other model
calculator will cause an error.
• Refer to the following if an error message appears on the OS 2.00 calculator when you are
sending data to another calculator model.
Invalid Data Size
- Matrix data exceeds 256 rows or 256 columns*
1
- List data exceeds 256 lines
- Table data exceeds 256 rows
- Recursion table data exceeds 256 lines*
1
*
3
- EQUA mode input data includes 4 to 6-degree equation
To Next Page
Loading...
Need help?
General
