20051101
8. Use number keys b through e to specify the unit for the value you specified in step 6.
• This displays a confirmation screen like the one shown below.
2-4
Using the Setup Wizard
7. After inputting total sampling time value you want, press w. This displays the “Select
Unit” screen.
10. Press number keys described below to specify what you want to do with the setup you
have configured.
b(Start Setup) ............... Starts sampling using the setup (page 8-1)
c(Save Setup-MEM) ..... Saves the setup (page 6-1)
d(Convert Program) ...... Converts the setup to a program (page 7-1)
9. If there is not problem with the contents of the confirmation screen, press 1.
If you need to change the setup, press 6 or J. This will return to the screen in step 4
(for setting the total sampling interval), where you can change the setting.
• Pressing 1 will take you to the final Setup Wizard screen.
To Next Page
Loading...
Need help?
General
