— 13 —
PARAMETERS
PARITY
EVEN ODD NONE
BPS (x100)
12 24 48
TO SELECT : [ ] [ ]
[ ] [ ]
TO SET : [ EXE ]
NONE
96
COMMUNICATION
PARITY : NONE
BPS : 9600
F1: TRANSMIT
F2: RECEIVE
F6: PARAMETERS
TRN RCV PRM
The pointer indicate which parameter you can change. Use and to move the highlighting and change
the parameter where the pointer is located.
Use and to move the pointer up and down.
After the parameters are highlighted the way you want, press
EXE
to store them.
• To abort the parameter setting procedure and return the settings to what they were before you changed
them, press
AC
before pressing
EXE
to store the parameters.
4-4. USING ALL TO SEND ALL DATA
The following procedures show how to send all data, from Program to Equation from one fx-7700GE unit
to another.
• Warning!
The following operation causes data in the seven applicable memory areas (program, function memory,
matrix memory, single-variable and paired-variable statistical data memory, value and extended
mempry, graph function memory, and equation coefficient memory) of the receiving unit to be replaced
by the received by the received data. Make sure that you do not need the data stored in the receiving
unit before you start this operation.
EXE
To Next Page
Loading...
