Casio Fx-82AU PLUS II - Initializing Calculator Settings

format. Outside the specified range, results are displayed using non-
exponential format.
Norm 1: 10
-2
> |x|, |x| ≧ 10
10
Norm 2: 10
-9
> |x|, |x| ≧ 10
10
Example: (LineIO) 1 ÷ 200 = 5 × 10
-3
(Norm 1)
0.005 (Norm 2)
Specifying the Fraction Display Format
To specify this
fraction display
format:
Perform this key operation:
Mixed (SETUP) (ab/c)
Improper (SETUP) (d/c)
Specifying the Stat Format
Specifies whether or not to display a FREQ (frequency) column in the
STAT Mode Statistics Editor.
To specify this: Perform this key operation:
Show FREQ Column (SETUP) (STAT) (ON)
Hide FREQ Column (SETUP) (STAT) (OFF)
Specifying the Decimal Point Display Format
Specifies whether to display a dot or a comma for the calculation result
decimal point. A dot is always displayed during input.
To specify this
decimal point
display format:
Perform this key operation:
Dot (.) (SETUP) (Disp) (Dot)
Comma (,) (SETUP) (Disp) (Comma)
Note
•
When dot is selected as the decimal point, the separator for multiple results is a
comma (,). When comma is selected, the separator is a semicolon (;).
12