E-21
Step?
Input the increment step (Default = 1).
Note: The Step specifies by how much the Start
value should be sequentially incremented as the
number table is generated. If you specify Start = 1
and Step = 1, X sequentially will be assigned the
values 1, 2, 3, 4, and so on to generate the number
table until the End value is reached.
• Inputting the Step value and pressing = generates and displays the
number table in accordance with the parameters you specified.
• Pressing A while the number table screen is displayed will return to
the function input screen in step 2.
To generate a number table for the functions
(
x
) =
x
2
+
2
1
and
g(x) = x
2
−
2
1
for the range –1 x 1, incremented in steps of 0.5
B
N3(TABLE)
1N(SETUP)c4(TABLE)2(f(x),g(x))
S)(X) x+ 1 ' 2
=
• Pressing = without inputting anything for
g(x) will generate a number
table based on
f(x) only.
S)(X) x- 1 ' 2
=-1 =1 =0.5 =
Note: • The maximum number of rows in the generated number table depends
on the setup menu table setting. Up to 30 rows are supported for the “
f(x)”
setting, while 20 rows are supported for the “
f(x),g(x)” setting. • You can
use the number table screen for viewing values only. Table contents cannot
be edited. • The number table generation operation causes the contents of
variable X to be changed.
Important: The function you input for number table generation is deleted
whenever you display the setup menu in the TABLE Mode and switch between
Natural Display and Linear Display.
MathMath
MathMath
MathMath
MathMath
MathMath
To Next Page
Loading...
Need help?
General
