43
Stopwatch
Pressing •• D during an elapsed time operation stops the
hands at the split time. Elapsed time measurement continues
internally. After about five seconds, the hands will return to
normal elapsed time indication.
1/20-second timing is performed only for the first 30 seconds ••
after you start or restart an elapsed time operation. The
left dial (1/20-second) hand also jumps to the 1/20-second
position when you stop an elapsed time operation.
Pressing •• D while the stopwatch is stopped will reset
stopwatch to zero.
The following operations are not possible while the watch’s ••
hands are moving during a stopwatch elapsed time operation.
Split, reset
Use the
C button to enter the Stopwatch Mode as shown
under “Modes and Indicators” on page 16.
To Next Page
Loading...
