EN-4
1.
Connect the Wireless MIDI & audio adaptor to
the cq USB Type A port.
2.
Hold down the bp^ button until “[FUNCTION]”
appears on the display. Then release the
button.
This enters the FUNCTION mode.
3.
Use the bk U and bl I buttons to display
“WIRELESS”, and then touch bm ENTER.
4.
Use the bk U and bl I buttons to display
“Adaptor” and then touch bm ENTER.
5.
Use the bk – and bl + buttons to switch the
setting between “On” and “Off”.
• While the wireless function is enabled, the Bluetooth
indicator lights when the Digital Piano connects with
the paired external device. The indicator is unlit when
the wireless function is disabled.
6.
To exit the FUNCTION mode, hold down
bp EXIT until “[FUNCTION]” disappears from
the display.
■ Notification Tones
A change in the Bluetooth connection causes a notification
tone to sound.
1.
Hold down the bp^ button until “[FUNCTION]”
appears on the display. Then release the
button.
This enters the FUNCTION mode.
2.
Use the bk U and bl I buttons to display
“WIRELESS”, and then touch bm ENTER.
3.
Use the bk U and bl I buttons to display
“Notification Vol” and then touch bm ENTER.
4.
Use the bk – and bl + buttons to change the
setting.
• You can specify a volume value from 0 to 127.
• To return to the initial default setting, touch bk – and
bl + at the same time.
5.
To exit the FUNCTION mode, hold down
bp EXIT until “[FUNCTION]” disappears from
the display.
Enabling and Disabling the Digital
Piano’s Wireless Function
This type of
connection:
Sounds this notification tone:
Connection with a
Bluetooth audio device
Rising piano tone melody
Disconnection from a
Bluetooth audio device
Falling piano tone melody
Connection with a
Bluetooth Low Energy
MIDI device
Rising vibraphone tone melody
Disconnection from a
Bluetooth Low Energy
MIDI device
Falling vibraphone tone melody
Adjusting the Notification Tone
Volume Level
To Next Page
Loading...
Need help?
General
Weight and Dimensions
