EN-6
■ To adjust the volume level of AUDIO IN jack input
1.
Hold down the bp^ button until “[FUNCTION]”
appears on the display. Then release the
button.
This enters the FUNCTION mode.
2.
Use the bk U and bl I buttons to display
“AUDIO IN JACK” and then touch bm ENTER.
3.
Use the bk U and bl I buttons to display
“Volume” and then touch bm ENTER.
4.
Use the bk – and bl + buttons, or cm Knob
(K1) to change the setting.
• You can set the volume within the range of 0 to 127.
• To return to the initial default setting, touch bk – and
bl + at the same time.
5.
To exit the FUNCTION mode, hold down
bp EXIT until “[FUNCTION]” disappears from
the display.
■ To change the center cancel setting of AUDIO IN
jack input
1.
Perform steps 1 and 2 under “To adjust the
volume level of AUDIO IN jack input”.
2.
Use the bk U and bl I buttons to display
“Center Cancel” and then touch bm ENTER.
3.
Use the bk – or bl + buttons to switch the
setting between “On” (center cancel enabled)
and “Off” (center cancel disabled).
4.
To exit the FUNCTION mode, hold down
bp EXIT until “[FUNCTION]” disappears from
the display.
You can connect audio equipment or a music amplifier to the
Digital Piano and then play through external speakers for
more powerful volume and better sound quality.
• Turn off the external device when making connections.
After connecting, turn down the Digital Piano and
external device volume levels whenever turning power
on or off.
• After connecting, turn on the Digital Piano and then the
external device.
• If keyboard notes are distorted when they are sounded
from external audio equipment, lower the Digital
Piano’s volume setting.
Connection requires commercially available connecting cords,
supplied by you.
Outputting Digital Piano Notes
Through an Amp or Audio
Equipment
Guitar amplifier
Keyboard amplifier, etc.
RIGHT (Red)
LEFT (White)
Pin plugs
Audio amplifier AUX IN jacks, etc.
dk LINE OUT jacks
(Standard jack (6.3mm))
To Next Page
Loading...
Need help?
General
Weight and Dimensions
