3
Initialization (for SE-S400/SE-S3000)
Initializing the cash register
Automatic initialization
Use the following procedure to initialize the cash register before using it for the rst time after you purchase it.
1. Install the two memory backup batteries.
2. Plug the cash register into a wall outlet.
3. Read the printouts and follow the procedure printed on the chit. Select the country and language from
the list then press a key. If you want to skip this step, just press s key.
4. Follow the procedure on the display to set the date and time.
• At this time, “00000000” appears on the display and the printer operates for a minute. Initialization is
complete when the printer stops operating.
CAUTION!
Automatic initialization (which clears all sales and programming data stored in the register's memory)
is performed whenever all power (both the backup batteries and power through power cord) is cut
from the cash register and then restored. The program data stored in the ash memory is restored.
Remember…
Main power cut by:
• Unplugging the cash register
• Power failure
Backup power cut off by:
• Removing the batteries
• Dead or low batteries
Automatic initialization when the
main power is restored and the
mode switch is set to any position
besides OFF.
+ =
Manual initialization
Use the following procedure to initialize the cash register and clear all transaction data and program data
from its memory.
1. Insert the mode key marked “PGM” into the mode switch.
2. Turn the mode switch to the OFF position.
3.
While holding down the
f (SE-S400) j (SE-S3000)
key, turn the mode switch to the PGM position.
4. Release the f (SE-S400) j (SE-S3000) key.
5. Enter
A B C D E
and press the s key. (A, B, C, D: Refer to the section below.)
A. Language selection This specication denes the language
to use in receipt/journal printing.
English
2
0
Dutch
2
3
Danish
2
6
Portuguese
2
9
French
2
1
German
2
4
Norwegian
2
7
Spanish
2
2
Swedish
2
5
Finnish
2
8
B. Area/monetary mode This specication denes the area and
the decimal position.
German
2
4
Two decimal place
2
1
No decimal place
2
3
C. Department number This specication denes the number of
department keys.
SE-S400
2
25
SE-S3000
2
30
D. Program 4 mode This specication denes Program 4
mode availability.
w/o PGM4
2
0
with PGM4
2
4
E. Number of PLU This specication denes number of
PLUs.
PLU 3000/Scanning PLU 2000
2
0
PLU 2000/Scanning PLU 3000
2
2
(SE-S400 only)