49
Program 3
Parameter Sheet
I/O parameter table programming
Refer to page 8 to enter the program mode.
Programming procedure
PGM
Select
“System Setting”
63s 6
::
98s
6: ~ : 6
a
6s
To the next record
Record No.
To a new record
Program data
Note: Please perform the following procedure after this program.
1. Power off the register, and connect all peripheral devices to COM ports.
2. Power on all peripheral devices.
3. Flag clear the register.
Program data (Address 01: for COM 1 port)
Description Choice Program code
Connected device:
Signicant numbers
::
D
4
D
3
Always “00”
;;
D
2
D
1
Program data (Address 02: for COM 2 port)
Description Choice Program code
Connected device:
Scanner = 20
Signicant numbers
::
D
4
D
3
Always “00”
;;
D
2
D
1
To Next Page
Loading...
Need help?
General
