6
Scanning PLU
Summary
You can easily register items with barcode label by using barcode scanner.
Without programming any PLU code, unit price nor linked department, you can register the items and
create the PLU programming data automatically by not found PLU registration.
You can input the PLU code by scanning the code or enter the PLU code and press ® manually.
The barcode system of this register is as follows:
Scanning PLU code
Input method
Sample barcode
Scanner PLU code manual input
EAN-13 (PLU type) √ 13 digits with check digit
EAN-8 (PLU type) √ 8 digits with check digit
UPC-A (PLU type) √ 10/11 digits without check digit
UPC-E (PLU type) √ 6 digits without check digit
Preparation
Just connect the handheld scanner (option) with the register.
1. Power off the register, and disconnect the AC plug from AC outlet.
2. Remove the connector cover.
3. Connect the scanner to the register and tighten two screws of the connector.
COM2(+5V) COM1(+5V)
Connect here
4. Replace the connector cover, reconnect the AC plug and power on the register.
To Next Page
Loading...
Need help?
General
