Casio SE-G1 - Page 2

A)
B)
C)
D)
E)
Casio SE-G1 Australian Quick Programming Guide
(please also refer to the “User Manual” supplied for further information if required)
Linking PLU’s to departments is only required if you are using PLU’s.
This process aids end of day reporting by grouping products (PLU’s)
with departments.
A) Turn Key to PGM position
B) Press
C) Enter
D) Press
The SE-G1 contains 24 departments, 8 are located on the keyboard and
an additional 16 are accessible using the “department shift" function.
Prices may be set to departments if required or entered manually from
with
in the sale
.
B) Press
D) Key price then press department key
A) Turn Key to PGM position
Note: Press dept shift once to access departments
9
~
16
or twice
for 1
7~24 etc.
IMPORTANT: Never use decimal point key when imputing
price.
C) Press “Dept Shift” if programming shift departments
otherwise skip to step D
A) Turn Key to PGM position
B) Press
C) Press
D) Enter
E) Press
The SE-G1 has an option of 999 PLU’s
. A PLU lookup function is provided
should you decide to use PLU’s on this register.
E) Press
Linking PLU’s to Departments
1
1
Programming Receipt Message
10
You can program receipt message text at the top
of the receipt. Up to 5 lines of text may be
programmed.
Receipt message sample
Flash Report
A flash report useful to monitor how much money
has been taken throughout the trading day.
A) Turn Key to the X position
B) Press
.
The following operation will print the end of day financial report.
Note: Using X Mode will print only while Z Mode will print and reset the figures ready for the next trading day.
13
Daily End of Day Report
Links PLU0001
to Department 4
This procedure sets $1.00 to PLU0001.
12
Setting prices to Departments
8
Setting prices to PLU’s
9
YOUR RECEIPT
THANK YOU
CALL AGAIN
Receipt message 1
st
line
Receipt message 2
nd
line
Receipt message 3
rd
line
Receipt message 4
th
line
Receipt message 5
th
line