1. On the QT-6100 to the right of the CF Card slot there is a round cut out
with a recessed RED reset button. On the QT-6600 this RED reset button
is above the CF Card slot
2. Turn the power OFF (the power switch is located on the left side of the
terminal behind the display)
3. Make sure the CF Card with the IPL file is in the card slot
4. Using a pen or pencil push and hold the RED reset button down
5. Turn the power ON and after a few seconds release the reset button
6. Instructions on the screen will tell you to press the reset button again,
pressing it again will start the IPL load process
7. When the IPL load process is complete, the following screen will appear:
8. Enter 20000 and press the OK button
Loading the IPL from CF Card to QT
To Next Page
Loading...
